​​​ Diamond Rib Reverse

Diamond Rib Reverse

COMMON APPLICATIONS

The Diamond Rib Reverse Profile further increases our line of metal roofing and siding panels. The Diamond Rib Reverse profile works great on agricultural and light commercial buildings. ​

3d View of Diamond Rib Reverse

Use

Wall

Gauges

26, 24

Coverage

36" width

Length

3' to 50'

Rib Height

3/4" reverse ribs on 6" centres

Fastener System

Exposed Fastener

Recommended Substrate

Open Spacing or Solid Substrate

Fasteners

See fastener section for sizes and uses

Flashing

See 3/4" flashing section for commonly used trim

Closures

Diamond LT, Diamond ST

Misc

See accessory section for more roofing accessories

Stock Colour Option

* Available in 26 and 24 gauge.
*** Colours are representative only, please visit your nearest branch for physical colour samples.

SMP STOCK COLOURS

Wood Grain Stock Colours (COMING MAY 2024)

Textured Stock Colours

Installation Help

The Diamond Rib Reverse panel is relatively easy to install. Simply lay your first sheet on the opposite end of your building of the prevailing winds and follow the recommended fastener pattern to the right. The second sheet can be laid with one rib overlapping the first panel, as per the picture to the right, and follow that pattern for each corresponding panel. For more in depth installation advice on panels, flashing and accessories, download/print our installation guide below.

Recommended Fastener Patterns

Side Lap fasteners recommended when installing as roof panel

Pre Drilling sheets in bundles is not recommended during installation for any steel sheets as this can cause hot burs which can rust to the pre painted or bare sheet and create a rusting appearance around the drill holes.