12-36 Reverse Panel
12-36 Reverse Panel
COMMON APPLICATIONS
The 12-36 Reverse Profile is an excellent choice for exterior walls on pre engineered, insulated metal buildings. The unique profile allows the panel to compress any pre eng drape insulation while causing minimal distortion to the panel itself.
3d View of 12-36 Reverse Panel
Use
Wall/Liner
Gauges
26, 24
Coverage
36" width
Recommended Substrate
Open Spacing or Solid Substrate
Length
3' to 50'
Rib Height
1-1/2" reverse rib on 12" centres
Fastener System
Exposed Fastener
Fasteners
See fastener section for sizes and uses
Flashing
See 1-1/2" flashing section for commonly used trim
Closures
12-36 LT, 12-36 ST, LP Vented 12-36 LT
Misc
See accessory section for more roofing accessories
Stock Colour Option
* Available in 26 and 24 gauge.
*** Colours are representative only, please visit your nearest branch for physical colours samples.
*** Colours are representative only, please visit your nearest branch for physical colours samples.
Installation Help
The 12-36 reverse panel is relatively easy to install. Simply lay your first sheet on the opposite end of your building of the prevailing winds and follow the recommended fastener pattern to the right. The second sheet can be laid with one rib overlapping
the first panel, as per the picture to the right, and follow that pattern for each corresponding panel. For more in depth installation advice on panels, flashing and accessories, download/print our installation guide below.
Recommended Fastener Patterns
Side Lap fasteners recommended when installing as roof panel
Pre Drilling sheets in bundles is not recommended during installation for any steel sheets as this can cause hot burs which can rust to the pre painted or bare sheet and create a rusting appearance around the drill holes.