Facebook-f Linkedin Pinterest Google

12-36 Panel

12-36 Panel

COMMON APPLICATIONS

Our 12-36 profile is the panel of choice for industrial and light commercial metal roofing and siding applications, and is an excellent choice for pre-engineered metal buildings. The 12-36 profile provides the strength and durability to withstand the toughest conditions and is ideal for slopes as low as 1/12.

3D VIEW OF 12-36 Panel

Use

Roof/Wall

Gauges

26, 24

Slope

1/12 and greater

Coverage

36" width

Length

3' to 50'

Rib Height

1-1/2" on 12" centres

Fastener System

Exposed Fastener

​Recommended Substrate

Open Spacing or Solid Substrate

Fasteners

See fastener section for sizes and uses

Flashing

See 1-1/2" flashing section for commonly used trim

Closures

12-36 LT, 12-36 ST, LP Vented 12-36 LT

Misc

See accessory section for more roofing accessories

12-36 Spec Page
1-1/2" Flashing Guide
12-36 Load Table
Exposed Fastener Install Guide

Stock Colour Option

* Available in 26 and 24 gauge.

*** Colours are representative only, please visit your nearest branch for physical colour samples

SMP STOCK COLOURS

Wood Grain Stock Colours

Textured Stock Colours
26 Gauge Colour Chart
24 Gauge Colour Chart
Woodgrain/Textured Colour Chart

Installation Help

​​The 12-36 panel is relatively easy to install. Simply lay your first sheet on the opposite end of your building of the prevailing winds and follow the recommended fastener pattern to the right. The second sheet can be laid with one rib overlapping the first panel, as per the picture to the right, and follow that pattern for each corresponding panel. For more in depth installation advice on panels, flashing and accessories, download/print our installation guide below.

Recommended Sheet Install Pattern

Exposed Fastener Panel Installation Guide

Recommended Fastener Patterns

Recommended Fastener Pattern

Recommended Fastener Pattern at Eaves, Ridges & End laps

Side Lap fasteners recommended when installing as roof panel

Pre Drilling sheets in bundles is not recommended during installation for any steel sheets as this can cause hot burs which can rust to the pre painted or bare sheet and create a rusting appearance around the drill holes.