12-36 Panel
12-36 Panel
COMMON APPLICATIONS
3D VIEW OF 12-36 Panel
Use
Roof/Wall
Gauges
26, 24
Slope
1/12 and greater
Coverage
36" width
Length
3' to 50'
Rib Height
1-1/2" on 12" centres
Fastener System
Exposed Fastener
Recommended Substrate
Open Spacing or Solid Substrate
Fasteners
See fastener section for sizes and uses
Flashing
See 1-1/2" flashing section for commonly used trim
Closures
12-36 LT, 12-36 ST, LP Vented 12-36 LT
Misc
See accessory section for more roofing accessories
Stock Colour Option
* Available in 26 and 24 gauge.
*** Colours are representative only, please visit your nearest branch for physical colour samples
Installation Help
The 12-36 panel is relatively easy to install. Simply lay your first sheet on the opposite end of your building of the prevailing winds and follow the recommended fastener pattern to the right. The second sheet can be laid with one rib overlapping
the first panel, as per the picture to the right, and follow that pattern for each corresponding panel. For more in depth installation advice on panels, flashing and accessories, download/print our installation guide below.
Recommended Sheet Install Pattern
Recommended Fastener Patterns
Recommended Fastener Pattern
Recommended Fastener Pattern at Eaves, Ridges & End laps
Side Lap fasteners recommended when installing as roof panel
Pre Drilling sheets in bundles is not recommended during installation for any steel sheets as this can cause hot burs which can rust to the pre painted or bare sheet and create a rusting appearance around the drill holes.